Applies to: PropX-Pro, PropX-Motor, PropX-Outdoor, PropX-Mini. (The PropX-Tinker doesn't pair with the app — see its console reference.)
Before you start, you’ll need
- Your controller, powered on (its status light solid blue — see your model's troubleshooting page if it isn't)
- A computer with Bluetooth and the PropX Control Center app installed
- Time: about 2 minutes
Step 1 — Put the controller in pairing mode
On the controller, press and hold the Record and Output 1 buttons together for about 5 seconds, then release.
You'll see: the status light flashes purple — the controller is now discoverable and ready to pair.
Step 2 — Add it in the app
Open PropX Control Center and click Scan.
You'll see: your controller in the list. The characters after the dash are your controller's serial number — the same one printed on its label:
Model Name looks like PropX-Pro PropX-+ serial numberPropX-Motor PropX-Motor-+ serial numberPropX-Outdoor PropX-Outdoor-+ serial numberPropX-Mini PropX-Mini-+ serial number
Click Add next to your controller.
You'll see: it connect — no PIN required. Name it, name its outputs, and test them from the app.
Moving to a new computer?
Remove the controller from the old computer's app first. Then put it back in pairing mode (hold Record and Output 1 for 5 seconds until the light flashes purple) and add it on the new computer.
Pairing not working?
Make sure the status light is flashing purple before you Scan — if it isn't, hold the Record and Output 1 buttons a little longer. Your model's troubleshooting page covers scan and pairing problems: Pro · Motor · Outdoor · Mini