The map of your controller — every other page points back here.
Power ("9-24V DC - 5A")
9–24 V DC, 5 A max, via the center-positive power jack or the − + screw power terminal. Reverse-polarity protected: wired backwards it won't start, but won't be damaged. No fuse inside — the inputs and outputs have built-in protection.
Output pairs 1–8
Eight − + pairs on green terminal blocks (three bottom-edge connectors, one on the right edge), each switching up to 1.5 A. Wire a prop across one pair, + to +, − to −.
Close-up of the output terminal blocks IMG-PRO-TOUR-02 — photo coming soon⚠️ Warning: Never connect a prop drawing more than 1.5 amps to one output.
Trigger inputs 1–2 and Trigger Power
Two inputs (pins A and B, either way around) fired by 12 V or by ground; up to 2 A. Trigger Power (− +) feeds power to your sensors.
⚠️ Warning: Trigger Power passes your supply voltage straight through — a 24 V supply means 24 V at your sensors. Check every sensor's rating.
Speaker terminals ("4-8Ω Speakers")
Stereo R and L pairs (each + −) on a removable speaker plug. Use 4–8 Ω speakers; the amplifier delivers 65 watts total — two speakers or all into one.
AUX audio ("AUX / 5w Audio")
A quieter 5-watt output for headphones or small powered speakers — great for testing. (Confirming this is the 3.5 mm jack — #66.)
PROG A and PROG B ports
Two RJ45 sockets (network-style plugs) carrying DMX (stage-light control, 512 channels) or PropX Mesh (one cable linking several controllers). One job at a time — Mesh turns DMX off. PROG A carries an extra 5 V pin. Mesh role is set by jumpers inside (positions — #44).
LED strip port ("12V RGB / + D −")
Addressable LED strips up to 300 LEDs: + (12 V), D (data), − (ground). Set your strip's length in the app. A full 300-LED strip at full white draws about 4.5 amps — budget your supply for it.
MicroSD card slot
Sound files (MP3, up to 32 MB each) and firmware updates. The controller also has 32 MB of built-in storage, so a card is optional.
USB-C port
Setup and service by cable when Bluetooth isn't an option.
Mounting flanges
Mount through the enclosure flange holes. Footprint 163 × 89 mm (units to be verified — #49). No DIN rail.