The map of your controller — every other page points back here.
Power ("9-24V DC - 5A")
9–24 V DC, 5 A max — center-positive power jack or − + screw terminal. Reverse-polarity protected; no fuse (built-in protection). Pick a supply voltage your motor is rated for — the motor terminals drive at supply voltage.
Motor terminals 1–2 and PARK
Motor terminals 1 and 2 drive any brushed DC motor that matches your supply voltage and stays under the current limit (up to 10 A, adjustable). Either wire order — swap the two wires to flip "forward". PARK (one terminal) takes a home switch so "return to start" moves end in exactly the same place (the switch's second wire is being confirmed — #74).
Output pairs 1–2
Two − + switching pairs for extra props, 1.5 A each — wire across the pair, + to +, − to −.
Trigger inputs and Trigger Power
Two inputs (A/B pins, either orientation, 12 V or ground, 2 A) plus Trigger Power (− +) for sensors.
⚠️ Warning: Trigger Power equals your supply voltage — check sensor ratings.
Speaker terminals and AUX
Stereo R/L pairs, 4–8 Ω, 65 watts total (or one bridged speaker); plus a 5 W AUX output for quiet testing (connector — #66).
PROG A and PROG B ports (RJ45)
DMX (512 channels) or PropX Mesh — one at a time; PROG A carries an extra 5 V pin; mesh role set by internal jumpers (#44).
MicroSD and USB-C
MP3s (≤32 MB each) and firmware updates on MicroSD; 32 MB built-in storage; USB-C for setup and service.
Speed knob ("Speed — REV / FWD")
Enable dial control in the app and the knob drives the motor directly: center off, FWD/REV either side, further = faster.
Mounting flanges
Footprint 163 × 89 mm (units — #49). No DIN rail. No LED strip support on this model.